Št. zadetkov: 21
Izvirni znanstveni članek
Oznake:
dvoconski termodinamski model;0D modeliranj;tvorba NOx;dizelski motorji;kemijska kinetika;two zone modeling framework;0-d modeling;NOx formation;diesel engines;chemical kinetics;
This paper presents a control-oriented thermodynamic model capable of predicting nitrogen oxides (NOx) emissions in diesel engines. It is derived from zero-dimensional combustion model using in-cylinder pressure as the input. The methodology is based on a two-zone thermodynamic model which divides t ...
Leto:
2018
Vir:
Fakulteta za strojništvo (UL FS)
Doktorska disertacija
Oznake:
dissertations;doctoral thesis;internal combustion engines;advanced combustion concepts;alternative fuels;pollutants emissions;0D thermodynamic calculation;
Numerical and experimental methodologies were developed in the dissertation with the goal of improving internal combustion engine control and decreasing engine-out exhaust emissions leading to mitigated impact on the environment. An innovative numerical method for simultaneous determination of the p ...
Leto:
2019
Vir:
Fakulteta za strojništvo (UL FS)
Diplomsko delo
Oznake:
diplomske naloge;obnovljivi viri energije;promet;biogoriva;elektrifikacija;okoljski cilji do 2030;scenariji;
Skladno z evropsko direktivo o obnovljivih virih energije in nacionalnim energetskih in podnebnim načrtom je v Sloveniji določen ciljni delež obnovljivih virov energije v prometu za leto 2030. Te cilje je mogoče doseči z različnimi razmerji uporabljenih energentov in tehnologij, ki jih je potrebno o ...
Leto:
2022
Vir:
Fakulteta za strojništvo (UL FS)
Izvirni znanstveni članek
Oznake:
motorji z notranjim zgorevanjem;termodinamske analize;zamik zgornje mrtve lege bata;zamik tlaka v valju;algoritem izračuna zamika;internal combustion engines;thermodynamic analysis;TDC offset;pressure offset;offset correction algorithm;
An innovative computationally efficient method for the simultaneous determination of top dead centre (TDC) offset and pressure offset is presented. It is based on characteristic deviations of the rate of heat release (ROHR) that are specific for both offsets in compression phase and expansion phase ...
Leto:
2017
Vir:
Fakulteta za strojništvo (UL FS)
Izvirni znanstveni članek
Oznake:
diesel engines;FIR filters;harmonics;spectral analyses;
This study proposes a novel methodology for designing an optimum equiripple finite impulse response (FIR) filter for processing in-cylinder pressure traces of a diesel internal combustion engine, which serve as inputs for high-precision combustion analyses. The proposed automated workflow is based o ...
Leto:
2017
Vir:
Fakulteta za strojništvo (UL FS)
Izvirni znanstveni članek
Oznake:
tire pyrolysis oil;compression ignition engines;exhaust gas recirculation;gaseous emissions;injection strategy;particulate matter;
A pure tire pyrolysis oil produced from waste tires was utilized in a modern 4-cylinder, turbocharged and intercooled, automotive Diesel engine. Due to its low cetane number, cetane improvers, external energy addition or increased compression ratios are generally required for its use in Diesel engin ...
Leto:
2017
Vir:
Fakulteta za strojništvo (UL FS)
Izvirni znanstveni članek
Oznake:
tire pyrolysis oil;diesel engines;injection strategy;thermodynamic parameters;emissions;
Tire pyrolysis oil (TPO) represents a promising waste-derived fuel for Diesel engines with its main deficiency being lower cetane number compared to Diesel fuel. Until now, successful utilization of the TPO in Diesel engines was possible only by increasing its cetane number, increasing compression r ...
Leto:
2017
Vir:
Fakulteta za strojništvo (UL FS)
Izvirni znanstveni članek
Oznake:
oxygenated fuel;exhaust gas recirculation;biofuel;particulate matter;gas turbine;advanced combustion concepts;
To achieve a near zero emission footprint of combustion in power generation, introduction of fuels with low global warming potential, namely low-carbon or carbon neutral fuels and simultaneous reduction of harmful emissions through implementation of advanced combustion concepts is necessary. The stu ...
Leto:
2020
Vir:
Fakulteta za strojništvo (UL FS)
Izvirni znanstveni članek
Oznake:
recirkulacija izpušnih plinov;nadzor gorljive zmesi;curek;razprševanje;zgorevanje;sproščanje toplote;exhaust gas recirculation;mixture control;spray;atomization;combustion;heat release;
To support the ongoing energy transition and minimize the environmental footprint of combustion related technologies, the paper presents a novel approach for combustion control in gas turbines and burners. It relies on spatially targeted injection of inert components in the spray core where existent ...
Leto:
2022
Vir:
Fakulteta za strojništvo (UL FS)
Izvirni znanstveni članek
Oznake:
compression ignition engine;low temperature combustion;partially premixed combustion;tire pyrolysis oil;engine control;combustion parameters;emissions;
In the presented study, low temperature combustion was established with a direct injection of diesel fuel being a representative of high reactivity fuels and tire pyrolysis oil being a representative of low reactivity fuels. Tire pyrolysis oil was tested as a potential waste derived fuel for low tem ...
Leto:
2018
Vir:
Fakulteta za strojništvo (UL FS)